Halar^® *****

Manufactured from ECTFE, is a melt processable fluoropolymer. Because of its chemical structure, a 1:1 alternating copolymer of ethylene and chlorotriflouroethylene, Halar offers a unique combination of properties especially as a coating and a liner. Halar fluoropolymer coatings provide outstanding chemical resistance, good electrical properties, a broad-use temperature range from cryogenic to 300 ° F (150 ° C), and meet the requirements of UL-94 V-O vertical flame test in thicknesses as low as .007 (7mils). Halar is resistant to strong mineral and oxidizing acids, alkalies, metal etchants, liquid oxygen, and essentially all organic solvents except hot amines.

Click Here: HALAR® COMPATIBILITY CHART

Ryton™ ****

The Chemical name for this material is Polyphenylene Sulfide. This material is practically unaffected by many organic chemicals, even under conditions that will dissolve or destroy other plastics. There is no organic solvent known that will dissolve PPS at temperatures below 392 ° F (200 ° C), but some classes of organic chemicals have shown a tendency to permeate the PPS polymer matrix (especially at elevated temperatures) causing some plasticizing, swelling and a weakening of the plastic compound. These chemicals include amines (organic compounds containing unoxidized nitrogen), aromatic hydrocarbons and halogenated organic compounds. This material is unaffected by most water-based solutions of acids, bases or neutral salts. The primary exceptions are strong oxidizing acids, such as nitric acid, hydrochloric acid or peroxy acids. Relatively non-oxidizing acids, such as sulfuric acid and phosphoric acid have little effect on PPS except under extreme conditions, such as high temperature and high concentrations. For additional information regarding the effects of Strong Acids, Strong Bases, Organic Chemicals or any other compatibility issues, please visit the Ryton compatibility chart @:

Click Here: RYTON™ COMPATIBILITY CHART

Corrosion Fighting

Thermal (ARC) Spray Materials

Praxair/Tafa Arc Spray Aluminum Wire – 01T

Made exclusively for arc spraying, 01T Aluminum is highly resistant to atmospheric corrosion. The coating acts as a galvanic corrosion inhibitor and also forms an oxide film producing a protective coating, thus, is recommended under a variety of environmental conditions and is used exclusively on submerged water applications. For long-term anti-corrosive applications, aluminum should be covered with a protective 5-8 mil layer of a suitable sealer, in all but mild rural applications. Aluminum 01T meets the following specifications:

MIL-STD-2138A (SH), Metal Sprayed Coatings for Corrosion Protection 

Department of Defense MIL-W-6712C Table II, Aluminum

PWA 1320F

SNECMA DMR33-012

Garrett FP5045

GE CF6 Overhaul Manual operation number 70-49-40